If the plate runs to the right, the color steel tile equipment - the debugging method of the pressure plate of the color steel tile press machine is deviated. Pad the left corner (feeding rack) or lower the bottom level on the right side (the axis of which axis is deflected will be flat on the bottom of the axis of which axis, and the upper axis will fall with the bottom axis). This tile press is used to press the vacuum screw extruder when producing glazed tiles by wet method. A hydraulic press that accurately shapes and presses the extruded and cut rough tile blanks. The automatic tile press can be installed and used alone, but requires manual loading and unloading. It can also be equipped with an automatic loading rack and a blank unloading manipulator, an extruder, a tile cutting machine, a blank feeding machine and a tile conveyor line to form a tile blank. The production line does not require manual operation at all. There are six processes for turning over the workbench of the color steel tile press. In addition to the first-level mechanical indexing and positioning, it is also equipped with a set of precision positioning mechanisms to completely ensure the accurate positioning of the workbench mold during each stamping process. The slide table that installs the upper mold is a box structure, and the slide guide rails are connected to the fuselage. The upper guide rail has a large contact length. Every time the upper mold is stamped, the mud blank is stamped twice in the process. That is, after the upper mold presses the tile blank for the first time and is in place, the upper mold rises 10 mm to allow the mud blank to be fully exhausted. The mold presses the tile blank downwards until it is in place before returning to the highest position. Therefore, the mold has a long service life and the quality of the pressed products is good. Then from the first row to the last row, first make the four corners of the front and back rows of the color steel tile press equipment the same height from the upper end of the bottom shaft of the frame. Find a thread to straighten, check whether the lower shaft is in a straight line, and adjust the left and right sides of the lower shaft to be horizontal. Then tighten the lock nuts on both sides and center the first and last rows of color steel tile equipment. The center of the intermediate wheel draws a straight line forward and backward. After adjusting the gap between the upper and lower shafts, the machine can be adjusted along the straight line.

Hope to adopt