1, according to the volume and shape of the goods, adjust the fork distance to make the left and right forces uniform.

2. Before starting the operation, please pay attention to the stacking of goods around the forklift and keep the forklift 20-30 cm from the ground to prevent the goods from being knocked down; When entering or leaving the warehouse gate or turning, you should whistle.

3. When picking goods or pallets with a fork, the knife and fork should be horizontally inserted into the jack of the pallet to avoid collision. Try to lift the fork at the back slightly, and then tilt the mast backwards.

4. When unloading pallets or goods, first lower the fork to a position about 10 cm above the ground or the top of the goods, and then tilt the gantry forward to a vertical state. After putting down the pallet or goods, pull up the fork.

5. Strictly implement the "five forks" in operation: the material center of the goods exceeds the load center of the fork, and the fork will not fork when the longitudinal stability decreases. When a single fork is tilted, the fork will not fork. If the cargo pile is unstable, the fork will not fork. When the goods are damaged, the fork tip may not be able to fork up. When the rated load of the forklift exceeds or the load quality is unknown, do not use the forklift.

6. When unloading, it is forbidden to shake the turntable, rotate the turntable or unload the goods by "archery" to avoid damaging the fork.

7. When retrieving fragile, valuable or unstable goods, or when the goods exceed the height of the gantry, the safety rope should be fastened, and there should be special personnel to guide them when necessary.

8. When forking goods on the platform, the fork can only fork forward with the platform. When the forklift truck must be carried horizontally, certain safety protection measures should be taken.

9. When two forklifts load and unload the same goods at the same time, someone should guide and contact them.

10, it is forbidden to hit or drag the goods with a forklift, hit the doors or vehicles with a forklift, or drive or lift with a forklift.

1 1. When loading, unloading or transporting containers, handle them smoothly, and do not pile them up or push them. When stacking, it is forbidden to put the container flat, upside down or hit it with a forklift.

Extended data

A, forklift truck daily maintenance content:

1. Check the specific gravity and height of the battery electrolyte. The height of electrolyte should be 10 to 15 mm above the separator. Tighten the plug and check whether the electrode and wire connector are secure.

2. Wipe the dust off all parts of the machine.

3. Check the engine oil quantity (internal combustion forklift).

4, the reliability of the clutch and brake pedal free stroke operation, check whether there is oil leakage.

5. Whether the connectors of various circuits are firm and whether various instruments are sensitive and effective.

Second, the forklift truck in the boxcar safety requirements:

When there is no platform outside the boxcar, the opening of the door should not exceed the width of the forklift, otherwise it must be protected. There should be a ferry board at the junction of the platform and the carriage. Its slope shall not be greater than 20%. When the car floor is rotten and damaged, it is necessary to lay steel plates.