1. Check the relevant surfaces of piston, cylinder barrel and installation guide sleeve to ensure that they are clean and free of burrs and edges.

2. The installation tool should be smooth, without sharp edges and corners, so as to ensure that the seal will not be damaged in any form during installation.

3. During installation, a small amount of grease can be applied to the relevant surfaces of the seal and cylinder barrel to facilitate installation, but no grease is allowed to remain between the rubber elastomer and the sliding sealing ring, otherwise the sealing performance will be affected.

4. Whether installed vertically or horizontally, the concentricity of piston and cylinder should be maintained. Excessive eccentricity may damage the seal.

5. The installation speed should not be too fast, otherwise the seal will be damaged.

Extended data

Classification description of hydraulic sealing ring

1 o-ring is a kind of circular element with simple structure, easy manufacture, reliable sealing and low friction, so it is widely used, which can be used for sealing both fixed parts and moving parts.

2. The cross section of the Y-shaped sealing ring is Y-shaped, which has wide applicability and good sealing effect. Commonly used for sealing between piston and hydraulic cylinder, piston rod and end cover of hydraulic cylinder.

3.v-shaped sealing ring is composed of support sealing ring, sealing ring and pressure ring with different shapes. V-shaped sealing ring has large contact surface and reliable sealing, but it has large friction resistance, mainly in hydraulic cylinders with low moving speed.

References:

Baidu encyclopedia-hydraumatic sealing element