● There is always explosive hydrogen around the battery. The battery must be kept away from sparks and open flames.
● When operating the battery or working near the battery, please be sure to wear appropriate eye protection devices and remove rings, bracelets and other jewelry.
● Don't lean over the battery when jump starting.
● Do not let the battery liquid contact the eyes, skin, clothes or the paint surface of the vehicle. Battery solution is a corrosive sulfuric acid solution, which can cause serious burns. Once any object comes into contact with battery liquid, it should be washed with plenty of water immediately.
● Please keep the battery out of the reach of children.
● The rated voltage of the auxiliary battery must be 12 volts. Using batteries with incorrect rated voltage will damage the vehicle.
● Never try to start a frozen battery. Otherwise, the battery may explode and cause serious injury.
QR25DE engine model
MR20DD engine model
1. If the auxiliary battery is on another car (b), please park the two cars (a) and (b) where their batteries can be close to each other.
If the battery of the vehicle (A) equipped with the intelligent key system is exhausted, the ignition switch cannot be switched from the "locked" position to other positions; If the steering lock is engaged, the steering wheel cannot be moved. Connect the jumper cable to the auxiliary vehicle (b) before pressing the ignition switch and opening the steering lock.
2. Use the parking brake.
3. Move the shift lever to the "P" position.
4. Turn off all unnecessary electrical systems (headlights, heaters, air conditioners, etc.). ).
5. Press the ignition switch to the "lock" position.
6. Remove the vent cover on the battery (if equipped).
7. Cover the battery with a completely wrung wet cloth to reduce the explosion risk.
8. Connect jumper cables (①, ②, ③, ④) in the order shown in the figure.
● Be sure to connect the positive electrode to the positive electrode and the negative electrode to the body ground. Never connect it to the negative electrode of the battery.
● Ensure that the jumper cable does not touch the moving parts in the engine compartment.
● Ensure that the clip of jumper cable does not contact with any other metal.
9. Start the engine of the auxiliary vehicle (B) and run it for several minutes.
10. Press the accelerator pedal of the auxiliary vehicle (b) to about 2000 rpm.
1 1. Start the engine of the crossover (a) in a normal way.
It should be pointed out that:
Never make the starter work for more than 10 seconds. If the engine does not start immediately, turn the ignition switch to the "OFF" position, wait at least 10 seconds, and then try again.
12. After the engine is started, please carefully disconnect the jumper cables (④, ③, ②, ①) in the reverse order as shown in the figure.
13. Remove and discard the rag, as it may be contaminated by corrosive acid.
14. Close the vent cover (if removed).