760 angle bracket is divided into middle bracket and side bracket. Before installing the plates, the brackets are fixed on purlins, and most of them are welded. The plates are buckled on the bracket, and the overlapping mode between the plates is occlusion. Auxiliary tools include manual occlusal pliers and electric edge sewing machine.

The nail must be hit in the middle of the tile bone to have waterproof effect. The fixed spacing of special nails is 500mm- 100mm (preferably 4 nails/m2). Special nails should be nailed in the direction of the roof at the lower end of the tile to achieve a beautiful and clean sealing effect.

When installing the cornice cover with ridge tile of sealing strip, divide the sealing strip into two halves, press it on the roof with ridge tile and fix it with special nails. The joint of the side tile is sealed with cement and then the ridge tile is directly covered, and the bottom of the ridge tile is trimmed with a small tile file. The lower end of the tile, that is, the eaves, is directly installed with a cornice cover, and the joint of the ridge tile is fixed with screws. The control interface is trimmed with scissors, overlapped and sealed with glass glue.

Extended data

assembling work

Proper use of special nails:

1, special nails must be nailed in the middle of tile bone to have waterproof effect.

2. The fixed spacing of special nails is 50 cm ~ 100 cm (preferably 4/㎡).

3, special nails must be nailed from the bottom of the tile to the roof to have a beautiful, sealed and tidy effect.

Install the roof tile cornice cover of sealing strip:

1. Divide the sealing strip into two halves, press it on the roof according to the tile type, cover the roof tile and fix it with special nails.

2. The joint of side tile is sealed with cement and then directly covered with ridge tile, and the bottom of ridge tile is trimmed with small tile file.

3. The lower end of the tile, that is, the eaves, is directly installed with the eaves cover and fixed with screws.

4. At the joint of ridge tile, trim with scissors to form the control interface, then overlap and seal with glass glue.

Waterproof treatment of protruding parts.

Make a V-shaped material first. You can use different materials and specifications, depending on the actual situation. Install the water knot at the bottom and lay the colored steel tile on it.

Inclined plane connection installation.

Refers to the construction of installing water treatment at the bottom after two roof tiles are cut according to angle and length. Install absorbent material (i.e. gutter) under the ceramic tile first, and then finish it with waterproof glue or cement.

Baidu encyclopedia-colorbond tile