There are many ways to weave pendants. Here is a brief introduction to the knitting method of the beautiful pendant of Xiliufu Jewelry. Let's have a look.

Tools to be prepared for pendant rope play: perforated crystal pendant, pendant rope, a pair of scissors and a lighter.

Step 1: First, light one end of two ropes with a lighter, then quickly twist them into a wiredrawing shape by hand, and then subtract the redundant parts with scissors. Pay attention to safety and care when twisting.

Step 2: Thread both ropes into the eyelet of the pendant, pay attention to the back of the pendant, and leave a length of about 1cm at the eyelet, as shown in the figure.

Step 3: On the way, divide the above two ropes into rope 1 and rope 2, which is convenient for everyone to distinguish. First, put the rope 1 on top of the two ropes, then the rope No.2 bypasses the rope 1 from above, and then passes through the loop of the rope 1 from below.

Step 4: Then tighten the two ropes so that the knot is as close as possible to the eyelet, but not too tight.

Step 5-6: Put the rope 1 on the top of the two front-end ropes, and the rope No.2 bypasses the top of the rope 1, and then bypasses the bottom of the two front-end ropes, passing through the rope loop 1.

Step 7: After completing the steps in Figure 6, tighten the two ropes of the pendant to get the pendant rope playing method shown in Figure 7.

Step 8: Repeat step 3-7 for 3-4 times to obtain the sending method as shown in Figure 8. The knotting method here can also be repeated as needed.

Step 9: Cut off the excess rope with scissors, then burn the rope mouth with a lighter to flatten the rope mouth. At this point, the performance of the pendant rope is completed.