Current location - Plastic Surgery and Aesthetics Network - Jewelry brand - Bracelet rope weaving
Bracelet rope weaving
One,

1. First knit a 2 cm diamond knot and fold the rope in half for knitting. The picture below is distinguished by different colors. Press the yellow rope onto the red rope first.

2. Then come out from behind the red rope and leave a circle at this time.

The red rope passes through the circle left by the yellow rope from the front.

4. Tighten, repeat the above three steps to weave a diamond knot of about 2 cm, and then wrap the woven diamond knot once.

5, use a clip to buckle the eye, which is convenient for making corn knots.

6. Divide a red rope into four parts. The following figure is divided into numbers 1, 2, 3 and 4 to distinguish them.

7.2 line pressure 1 line, 3 lines pressure 2 lines, 4 lines pressure 3 lines, 4 lines crossing 1 line.

8. Repeat the above steps and weave to a satisfactory length, then you can tie the woven bracelet.

9. Put beads on the end of the knot and tie the knot with a lighter to complete the weaving of the bracelet.

Second, cross-braided rope: first, prepare the rope to form a 3cm circle. Bend one end of the rope from the top and then pass it through the circle. Twist the rope ring to the left in a cross shape with your right hand. Thread the other rope through the ring from left to right, and pay attention to adjust the tightness, which will affect the tightness of the braided bracelet. Twist the rope loop to the right again with your left hand to make the rope loop cross again. Then take the rope through the twisted loop. After reaching over, just tighten the rope.

Third, flat knot rope weaving: prepare two ropes; Tie the prepared horizontal rope in a knot on the vertical rope and tighten it. Thread the knotted rope under the vertical rope and tighten it. Repeat the above knotting and tensioning steps until the appropriate length is obtained.

Four, diamond knot method: prepare tools, first make a fast knot. The rope on the right goes around the rope on the right, and the rope on the left goes through the circle on the right. Repeat the above steps until the beads are woven to a suitable length. Tie a knot after editing.