1. Prepare some tools first, such as lighters, scissors, jewelry thread, ordinary jade thread, etc. The reason for using jewelry line is that the holes of some small pendants are generally small, and the jewelry line can pass through the holes of small pendants; Ordinary jade thread is slightly thicker than jewelry thread.

2. Thread the jewelry line through the pendant to form a circle.

3. Take the place where the jewelry line crosses as the main line, and start to tie a flat knot with the jade line, and tie it up and down from left to right. Pay attention to estimate the length of the pendant rope, such as the figure of the person wearing the pendant, and then adjust the length of the pendant rope, usually the appropriate size is better.

It can't be too short or too long, otherwise it will lose the aesthetic feeling of wearing and make the wearing effect not so good.

4. After the flat knot is finished, cut off both ends of the jade thread, and then light the thread end with a lighter, which is like this.

5. Pull the two ends of the jewelry line to both sides, to the end, cut off the excess line and light it with a lighter. In fact, after the combustion is completed, the rope end will not be too abrupt, which can block the roughness of this part.

Method two.

1, 4 pieces120cm0.8cm flat wax, 20cm at one end, and then braid a 60cm long four-strand braid. The length is determined by the size of your head circumference. Remember to put the pendant, face up.

2. Complete four strands, leaving one strand 1cm long, and then turn it back. Take another thread and make a short winding on it, and the wound thread will be inserted into the small hole.

3. Tighten two threads at the same time, cut off the upper thread and burn it, and do the same at the other end. Two of the threads are tied in diagonal knots, and the other thread on the left is also tied in diagonal knots on the shaft. If the shaft is wound unchanged, then tie in diagonal knots on the left, and the shaft should be straightened.

4. Wrap it on the other line on the left to make a left oblique knot, and wrap it on two shafts to make a right oblique knot respectively. The same is true on the right. A 6mm agate bead passes through the two windings oppositely, and the windings are tied with a left oblique knot on the left two shafts.

5. Make a right oblique knot and a left oblique knot on the two winding wires respectively, and do the same on the right side. Tie a diagonal knot on the two axes inside, then tie a diagonal knot on the two axes outside and tie a diagonal knot on the two axes outside.

6. Cut off all the extra threads and burn them, and then wrap a flat knot on the necklace rope.