1. Prepare a thin copper wire (guide needle) and an elastic thread about 80 cm long, fold them into two strands, and then use the guide needle to pass through the two strands to form four strands; 2. Put the beads in, leaving 2-3 round beads; 3. Pass the copper wire through the hole punched in the front of the brave, and pass the ball through the elastic rope; 4. Put the guide needle on the other end of the elastic rope and put on the left ball as shown in the figure; 5. Pass through the hole at the back end of the brave and then pass through the round balls that pass through in turn; 6. After tightening the elastic ropes at both ends, put on two ordinary ropes; 7. Pull the put rope slowly and forcefully into the round bead; 8. Cut off the extra elastic rope and a brave bracelet will be finished. If you don't understand, you can go to the Buddha's edge stone crystal net, which has pictures to teach you beading.