1. When the led light bar is a roll, please do not light the light bar.
2. It can only be cut at the place where the scissors mark is printed on the lamp body of the lamp strip, otherwise a unit will not light up.
3. When installing, please bend the lamp strip to one side to expose 2-3MM copper wire, and cut it clean with scissors without burr to avoid short circuit.
4. Do not connect the power supply when installing or assembling the light bar. Only when the connection and installation are correct can the power supply be turned on.
5. When installing the LED strip at low temperature, power on for a few minutes to make the lamp body soft and easy to bend, and then power off for installation.
6. During installation and use, please don't hit or beat the lamp with heavy objects.
7. Glue must be stuck on the end of the lamp tube before it can be trapped with the tail plug.
8. Only two pipes with the same specification and voltage can be connected in series with each other, and the total length of series connection shall not exceed the maximum allowable length.
9. Each interface must be firm and free from short circuit. When installed outdoors, each interface must be sealed with glass glue or other suitable methods to ensure that water at each interface can enter.
10. It cannot be installed in an environment with water, inflammable and explosive, and the use environment must be well ventilated.
1 1. Install and fix, and don't tie the lamp with metal materials such as iron wire, so as to avoid short burning of the lamp caused by iron wire falling into the lamp.
12. The power supply voltage should be the same as the voltage marked on the lamp tube, and appropriate safety devices should be installed.
13. Please don't wrap or cover the lamp with anything when using it.
14. When the lamp body is found to be damaged, please cut off this part immediately and do not continue to use it to avoid danger. 15. If flashing, running water and other effects are needed, please use the LED controller.
Led strip refers to the assembly of LED on ribbon FPC (flexible printed circuit board) or PCB hard board, so it is named because its products are shaped like ribbons. Because of its long service life (generally, the normal service life is 80 ~ 65438+100000 hours), it is green and environmentally friendly, and gradually emerges in various decoration industries.