112 Step by step reading
Step 1: Light the ends of two ropes with a lighter, screw the tips of the ropes together and pass through the holes in the jade before the ropes solidify.
2/ 12
Step 2: Separate the two ropes, turn the rope on the right over and bend it to the left. Then the left rope presses the right rope, goes around the back and passes through the hole where the right rope bends. Tighten the two ropes.
View the remaining 4 pictures.
Teach you a few small ways to distinguish between true and false jade pendants _ take less detours _ avoid being fooled
People who pay attention to the jade pendant are also watching.
Qingdao cuimanzhang jewellery advertisement
3/ 12
Step 3: Turn the left rope to the top, bend to the right, pull the right rope, go around the back, pass through the hole formed by the left rope and tighten the two ropes.
Look at the remaining 3 pictures.
4/ 12
Step 4: repeat step 2, turn the rope on the right over and bend it to the left. Then the left rope presses the right rope, goes around the back and passes through the hole where the right rope bends. Tighten the two ropes.
Look at the remaining 3 pictures.
5/ 12
After this step, it's basically OK. If it doesn't feel tight, you can repeat the third step. If you think it's ok, look down: the last step: cut the rope on both sides, leave a short section, and don't cut it too bald. Then light it with a lighter and stick it there after melting.
View the remaining 1 pictures.
6/ 12
Have you learned? The rope tied in this way is very tight and will not come back.
The following is the stretching method of jade lanyard: generally, the lanyard we buy is adjustable, and the lanyard made around it is adjustable. How to stretch to a length that suits you?
This is the case when you see the rope (below):
7/ 12
If it is too small for the headgear to fit in, pull the ropes on both sides (below):
8/ 12
At the end, the two wire hoops meet together, which is the maximum length at this moment (below):
9/ 12
After wearing it around your neck, take two beads and pull them to both sides together. When you reach the finish line, you will return to the original appearance (below):
10/ 12
At this time, if you think the pendant is a little too low and want to raise it a little, you can pull the two beads of the rope (don't pull the iron ring) to both sides (below):
1 1/ 12
Until the end, the two wire hoops meet together, and the beads hang outside. At this moment, the length is the shortest (below):
12/ 12
The adjustable lanyard can be adjusted at will, the necklace can be turned into a sweater chain, and the sweater chain can also be turned into a necklace.