1, first prepare the material to be used, the red line (choose by yourself, personally suggest that the red line has a diameter of 8mm). I used a red thread with a diameter of 8mm, a pendant (I can use whatever I like), a tool lighter and scissors.

2. Align the two red lines, then fold them in half to find the center point (not very accurate, just approximate location. ) and put your thumb in the middle.

Next, we began to weave diamond knots. As for the steps of diamond knot, I won't go into details. I have related experience in diamond knot knitting, so I can refer to it. Just tie five diamond knots and you can stop.

4. Thread the prepared pendant with a thread, and then weave five diamond knots equally on the other side. Pay attention to leave a line in the middle, not too tight.

5. Next, leave a little distance and start knitting four diamond knots on each side. The distance increases at one time, and then weaves three, two, 1. Note that both sides must be symmetrical.

6. After completing the above steps, prepare a 7.8cm thread, thread the four threads on both sides of the braided necklace rope together, put that thread below and tie a flat knot. Tie 5-6 flat knots, subtract the extra thread with scissors, but leave a little thread, then burn the dotted line with a lighter and stick it on the flat knot. Not easy to drop. (The flat knot is movable)

7. Put the beads on the back of the four lines. Put the thread in order and stick it behind the beads with a lighter.