Jewelry wearing strategy

Express number | 18-06- 17 04:43

Tools/raw materials

Red rope (6 strands, length 1-2m) is used for spinning beads (it can be made of gold, silver or other materials).

Method/step 1:

First, fold the red rope in half to make a diamond knot, leaving a round head, and the length should not exceed the length of the bead.

Second, make a diamond knot to reach the required length (with the calculation method of ring length)

3. One of the throwing lines passes through the transfer bead.

Fourth, then put in the round head.

Five, put back the transfer bead

Sixth, tighten the line.

Seven, two lines to tie a fast knot.

Eight, cut off the sling and burn it. Push the burnt part into the hole of the transfer bead. If the hole for turning the bead is too small, you can also turn over the diamond knot and carry it to the inside of the ring.

Nine, complete

X. Measure the length of the red rope ring of the diamond knot: the length of the ring = the length of the rotating bead+the length of the diamond knot. Remarks: Because the diamond knot will loosen slightly after wearing for a period of time, there is no need to worry about the error caused by the transfer of bead thickness. If the jewelry is beads or other styles of accessories, you can try it on in the seventh step (before locking the button) and then adjust it.