First, cross braided rope.

1. First, prepare the rope and form a 3 cm ring.

2. Bend one end of the rope from the top and then pull it through the circle.

3. Twist the rope ring to the left in a cross shape with your right hand.

4. Thread the other rope through the ring from left to right, and pay attention to adjust the tightness, which will affect the tightness of the braided bracelet.

5. Twist the rope loop to the right again with your left hand to make the rope loop cross again.

6. Then take the rope through the twisted loop.

7. After reaching over, just tighten the rope.

When finished, the bracelet is very simple and elegant to wear on your wrist. Have you learned how to knit this bracelet?

Second, flat knot braided rope

1 Prepare two ropes.

Tie the prepared horizontal rope in a knot on the vertical rope and tighten it.

Pass the knotted rope under the vertical rope and tighten it.

4 Repeat the above knotting and tensioning steps until an appropriate length is obtained.

Third, the diamond knot method

1. Get your tools ready and tie a fast knot first.

2. The rope on the right goes around the rope on the right, and the rope on the left goes through the circle on the right.

3. Repeat the above steps until the length is appropriate.

Put on the beads.

5. Make a knot after editing.