Some jewelry display cabinets need to be pasted with solid wood skin, but many display cabinet factories can't always do it. Common problems are foaming and cracking. China shows the trading network to talk about how to avoid this problem.

1. The base material shall be flat, the uneven base material shall be rejected, and the deformed base material shall be rejected. If it does not meet the requirements, it should be reworked.

2. It is advisable to stick wood veneer with 0.2 mm by hand, and try not to exceed 0.25 mm. It is too thick and not hot, because the electric iron is not as high as the steam temperature attached to the machine.

3, the soldering iron temperature should not be too low, too low to burn through, of course, not too high, too high to burn, so the temperature should be appropriate;

4, the viscosity of the glue should be appropriate, and the content of the cured product should not be too low, too thin and sticky, easy to foam, too thick and uneven; Even glue, brand glue, bad glue, everything is in vain;

5, veneer to soak, and then dry until the humidity is suitable for reuse; Wood veneer can't be too wet or too dry. If it is too dry, it will open. This is mainly based on actual operation experience, and there is no suitable value.

6. The end face or curved surface should be ironed several times, paying attention to the interval;

7. Try not to cut off the end-face decorative panel with a blade, and polish it off with a wooden mat and coarse emery cloth;

8. Veneering is a delicate job, which needs to train careful professional operators. Every time these people operate, there are many experiments and the operation is standardized.

As long as you pay attention to the above points and be careful in the process of manual pasting, the jewelry showcase products that will be pasted will be natural and beautiful.