What is the length of the bracelet?
The length of the bracelet is generally 16cm. Bracelet, a kind of jewelry, is a chain worn on the wrist, mostly made of metal, especially silver, but also made of ore and crystal. Different from bracelets and bracelets, bracelets are chain-shaped and are mainly used to pray for peace, calm the mind and look beautiful.
Can the Pandora bracelet be shortened?
It's best to make this in a jewelry repair shop, because it will break directly if you make it yourself. It's not expensive to get it in a repair shop, but if you go to a shop that specializes in buying high-end bracelets (platinum, sterling silver, etc.), the repair price is not necessarily. ).
If it's a beaded bracelet, it's easier to hold. If it is much bigger, cut the thread to remove a few beads, and then put it on with elastic rope.
How to change Pandora's bracelet? Buy this watch maintenance gadget to replace the watch chain-watch regulator online. The price is around 10 yuan, which is not expensive. If you think even the postage is expensive, buy a full set, so you can use your watch if you have any problems in the future. Very convenient. The instrument regulator is suitable for steel band watches. Take the watch that needs to modify the length of the bracelet and observe the direction of the arrow on the bracelet. The direction of the arrow should follow the direction of the needle, not upside down. If you want to remove more than two sections, you should remove the bracelet at the left and right ends respectively. Put the bracelet of the handle into the card slot in the middle of the watch regulator, select the connecting rod node to be taken out, rotate the handle, screw the punching needle into the node, and pop up the card needle. Gently pull out the clamping needle with your hands and small pliers. Remove the bracelet joints and see how wide and narrow the wrist is. Try it on your wrist. If it is still long, remove another paragraph in the same way. Finally, connect the broken ends of the watch chain and insert the clamp needle in the original head-to-tail direction. Then put a soft cloth on it with a small hammer and put the ingot back. If there is still a small head, you can put the bracelet in the watch adjuster and push it in the opposite direction.