Watch should be worn carefully and wiped carefully after wearing, especially where there are sweat stains and water stains. If there are other problems, you can hand them over to professionals for maintenance. In addition, if you wear a new watch, be sure to tear off the film on the back of the watch. Don't think that the film can slow down the damage of the watch, but the dirt in the gap of the film will cause more damage to the watch case due to the soaking of sweat.

Belt maintenance

1, to prevent contact with moisture and moisture, and to avoid discoloration and deformation of the belt.

2, to prevent exposure to the sun for a long time, so as not to fade the belt.

3, because the cortex is easy to penetrate, it is necessary to prevent contact with oily things or cosmetics.

Extended data:

Wristwatch water treatment

1. If the watch is soaked by water, it can be tightly wrapped with several layers of toilet paper or absorbent flannel, placed near the 40-watt bulb for about 15 cm, and baked for about 30 minutes to evaporate the water vapor in the watch. Never bake the watch cover directly by the fire to avoid thermal deformation of the watch.

2. Put the watch inward and the bottom shell outward, and put it on your wrist. After two hours, the moisture can be eliminated. If the water is seriously flooded, it is best to send it to the watch shop immediately to wipe the oil stain, remove the moisture from the movement and avoid the rust of the parts.

3. Put the granular silica gel into a closed container together with the watch with accumulated water. A few hours later, when I took out my watch, the accumulated water completely disappeared. This method is simple and economical, and has no harm to the accuracy and life of the instrument. Silica gel that absorbs water many times can be dried at 120℃ for several hours, and its water absorption capacity is renewable and can be used repeatedly.

Reference: Baidu Encyclopedia-Observation