2? -? Hold the middle part of the line horizontally with both hands.
3? -? Then wrap the thread between the index finger and thumb, as shown.
4? -? Take the thread off your thumb, put it on the thread of your index finger and squeeze it tightly, as shown in the figure.
5? -? Then pull out the thread just wrapped around your index finger from behind.
6? -? Then pass through the line around the root of the index finger.
7? -? After passing through, as shown in the figure.
8? -? Grasp the thread with your thumb and turn your hand over.
9? -? Form a "small flower basket" shape.
10? -? Then, respectively, wind the lower two wires clockwise around the marked one, and then pass through the hole in the middle (shown by the yellow arrow). Pay attention to always keep the mark in the middle position.
1 1? -? Similarly, the line on the other side will bypass the marking line clockwise and then pass through the hole in the middle, as shown by the yellow arrow in the figure.
12? -? Pass through it, and then gently pull the ends of the line. At this point, the knot is finished, and then tighten the knot.
13? -? Reeling is a key step, and the mark we just made will work at this time. The key point is to always take this line as the center as the mark, first pull one side of the mark line, and then tighten it bit by bit along the direction of this line, paying attention to keeping the mark in the center. Then pull the other side of the marker line.
14? -? Similarly, it should be tightened slowly along the direction of the line. This process may be repeated several times.
15? -? Adjust it to the time shown in the figure.
16? -? To make the button look good, thread the bottom thread through the top sleeve.
17? -? Continue to tighten according to the method just now. At this time, some tools can be used to assist, such as awls or tweezers.
18? -? After adjustment, pull out the thread ends and marking lines that have just been put in, and it is finished. Look! Does the effect after weaving look like a beautiful little bud?