You can listen to the noise on the floor and walk back and forth on it. But we should step up the pace, especially in some special places, such as the position near the wall and the position of opening the door. These places should pay more attention to acceptance. If you find a noisy part, you need to walk repeatedly, and then determine the specific location of the abnormal sound and mark it. This noisy position may be caused by improper operation during construction.

Step 2 look at the appearance

The acceptance of composite floor should check whether the floor is deformed or warped. Acceptance method of floor paving: use a 2-meter ruler to lean against the floor to make its flatness not more than 3 mm, and take more positions for measurement. The qualified rate is above 80%, which is qualified; Otherwise, it is unqualified.

If it is found that the floor is partially arched, it may be that the quality of the floor is not good, which is a very serious quality problem.

3. Look at the color.

Need to check whether the color of the floor is consistent. If the color difference is too serious and affects the overall appearance, you can ask for a replacement. However, if the colors are too consistent, you should also pay attention. At this time, it depends on whether the color and pattern of the floor are consistent.

Extended data:

Do a good job of acceptance after decoration, mainly floors, electrical appliances, lamps, wallpaper, corners, sanitary ware, etc.

1, floor inspection and acceptance shall ensure that the floor is clean, dry, stable, smooth and free of floating soil, and that the floor surface is smooth, the paint surface is free from damage, obvious scratches and obvious noise in the main walking area;

2, electrical inspection, check whether the power cord connector is exposed, check whether the grounding wire is connected, and check whether the air conditioner is installed above the bed, at the end of the bed or at the diagonal of the door;

3, lamps and lanterns inspection, check whether the heat preservation is done well, especially in the kitchen and bathroom, check whether the hanger of the chandelier is an iron expansion bolt, and check whether the plastic pipe expands and needs to be replaced immediately, because the plastic pipe expands and ages easily;

4, wallpaper inspection, use a scraper from top to bottom, from inside to outside, gently scrape off the wallpaper, if there are too many bubbles, the glue can not be squeezed out, resulting in uneven wallpaper, should let the decorator replace it;

5, check the corner, whether there is a crack in the wall, whether there is a bump, whether the wall leaks;

6, sanitary ware inspection, pay attention to the firmness of sanitary ware, check the tightness of pipeline interface, the hole of the drain plug should be aimed at the overflow hole of the washbasin as far as possible, and the upper end face of the drain plug after splicing should be lower than the bottom of the washbasin. Check whether the height of hot and cold faucets or mixed faucets in the bathtub is higher than the upper plane of the bathtub 150mm, and whether the height of shower nozzle from the ground is higher than the highest in the home.

People's Network-What should we pay attention to in the acceptance work after renovation?

Phoenix net-how to check and accept the house after decoration