1, square origami, two opposite sides and two oblique sides are folded in half, and unfolded after pressing the crease.

2. After the opposite sides are folded in half, the two corners are folded inward according to the existing creases to form a triangular double layer with creases inside.

3. After the two corners at the bottom of the upper layer are folded to the apex and creased, the inside of the folded triangle is pushed down from the opening to form two small squares.

4. Fold the upper corners of two small squares diagonally.

5. Turn the origami and repeat steps 3-4.

6. Fold down the upper corner of the origami, press out the crease, and then unfold it.

7. Fold the paper from the opening under the origami to form three parts: upper, middle and lower.

8. The two corners of the middle part of origami are folded outward and flattened in the opposite direction, as shown in the figure.

9. Turn the origami upside down and erect a double triangle. Expand a triangle with four sides, and press each side clockwise according to the existing crease. Hold the vertex of the triangle with and twist it clockwise, while rotating the peripheral folding angle.

10, roses can be shaped at will, lace can be turned at will, and flower hearts can be pressed at will. Adjust it to your liking.

Second,

Preparation materials: toilet paper and cable ties.

Specific steps: 1, prepare a piece of toilet paper about 40cm long, and then fold it in half according to the width shown in the figure;

2. Fold into the shape shown in the figure;

3. As shown in the figure, roll the paper towel inward once;

4. Hold the bottom and don't let go, as shown in the figure, repeatedly fold the other side outward;

5. When folding to the bottom, tie it tightly with a tie. If not, you can tidy up the edges of the flowers with glue. The "rose" made of toilet paper is finished!