Preparation of practical bamboo chicken skin The preparation method of practical bamboo chicken skin;

1. Fabrication of portal frame: 1. Material: spring steel wire with a diameter of φ 2 ~ 2.5 mm (preferably φ 2.3), brand "6 W-Mn". Too thin to insert, too thick to increase the total weight, dozens of sets are too heavy to carry up the mountain. 2. Rack size: There are two structures: integral and split. 3. Heat treatment after fabrication: 350℃ ~ 380℃, heat preservation for one hour, then natural cooling in the furnace, and finally shaping, correcting and painting (black or brown is the best).

2. Manufacture of ferrule: 1. Material: nylon winding thread (black or brown) or "Yulang" brand fishing line used in street shoe repair workshop, which can cut a single line with a length of 580mm; 2. Fold several single strands in half, tie a knot with a diameter of about 2 mm, and then twist it into a single ferrule strand with a diameter of 1 ~ 1.2 mm; 3. Make the steel strand into several 80mm single ferrules; 4. Set the completed single ferrule.

3. Assembly: Assemble the left and right portal frames as shown in the figure, and then install the ferrules in turn. As shown in the figure, the overlapping diameter of the two groups of ferrules is 1/3, which is beneficial to improve the success rate. Most of me put two rings on the chicken's neck at the same time, so it is not easy to run away. This layout is my experience for many years, and I hope to learn from it. There is also a rule of thumb, that is, put a little oil on the steel wire bundle before tying the ferrule to the gantry. When gluing and fixing, turn the gluing part of the ferrule several times when the glue is not solidified, and remember not to hang it with the steel wire, which is beneficial to the setting and position adjustment in future use.