2. Before long-term storage, the machinery should be maintained, the damaged parts should be repaired and thoroughly cleaned to maintain a good technical condition.
The arrangement and layout of the airport should ensure that the entrance and exit of any machine are not affected by other machines.
4, mechanical fuel control lever should be placed in idle position, joystick in neutral position.
5, the custody of the engine. Drain the cooling water from the engine. Change engine oil. New engine oil is usually neutral and will not corrode the metal parts of the engine. Fill the fuel tank with diesel oil to prevent it from rusting. Preservatives should also be added if conditions permit. During the shutdown, the engine should be started once a month to make the machine run for a short distance, so that new oil films can be established in the lubrication parts of various parts to prevent rust. Attention: Fill up the cooling water before starting and drain it at the end.
6. Storage of batteries. The battery should be taken out and put in a dry and antifreeze place. In order to keep the battery surface clean and dry, it is forbidden to place conductive objects on the battery. When disassembling the battery, cut the negative wire first and then the positive wire; When installing, connect the positive wire first and then the negative wire. Because the electrical system of the second-hand loader is grounded at the negative pole, this is to prevent short circuit when removing the battery. Lead-acid batteries should be recharged once a month.
7. Rust prevention treatment. Before warehousing, it is necessary to determine whether to touch up the paint or repaint the whole machine according to the peeling area of the external surface antirust paint. Working devices of second-hand loaders, such as screed of paver, bucket of loader, scraper of grader, etc. All the exposed metal parts are rusted with butter.