Current location - Plastic Surgery and Aesthetics Network - Plastic surgery and medical aesthetics - How to realize rounding in machining. For example, a square marble column with a side length of 20cm and a round edge is not drawn, but processed.
How to realize rounding in machining. For example, a square marble column with a side length of 20cm and a round edge is not drawn, but processed.
In general, after the marble square column is cut,

Plastic with plastic tools.

This kind of cutter is shown in the following figure.

Both sides are shaped arc blades.

According to the fillet you need, use as large an arc cutter as possible.

The tool material is of course a diamond grinding wheel.

After the cutter moves straight forward, it forms an arc angle.

Related articles
  • Jing Li's detailed introduction
  • Copywriting short sentences clean cure sunshine inspirational
  • Zhongshan plastic surgery recommendation
  • How to turn a round face into a oval face-10 shave to make up for the three-dimensional sense of the face
  • What kind of dog is this?
  • Will the insurance company compensate for the mental damage, lost time, nutrition, transportation and plastic surgery awarded by the traffic accident court?
  • Summer is too sunny, what should I do if my skin has dark spots? Is there a way to repair it?
  • Why did Qiu Yuhong enter the detention center?
  • Working hours of Pudong Vehicle Inspection Office in Qingjiangpu District of Huai 'an City
  • Excuse me, can the local people's doctor get rid of moles in dermatology? About how much? How to remove eyebrows, will they not grow eyebrows?

    • copyright 2024 Plastic Surgery and Aesthetics Network All rights reserved