1, the main shell of the stool must be a hard and thick paper shell. Draw a suitable height with a ruler and strokes. The height of the stool can be the same as that of the chair at home. Then cut this off with a knife.

2. Roll up the drawn paper, determine the diameter of the outermost circle of the cylinder as needed, then poke several holes at the two joints and tie them with ropes.

3. After the outer ring is fixed, continue to fill it until the inside of the spool is filled and the plug is firm. Finally, a circular cover is fixed at the top and bottom respectively.

Manufacture of paper table cloth cover

First, you need three parts of fabric:

1, a slender strip with a width of about seven or eight centimeters, and the length is about 1.5 times the circumference of the drum.

2. Circular cloth with a radius larger than that of the barrel 1-2 cm.

A rectangular piece of cloth is three or four centimeters longer than the circumference of the drum and five or six centimeters wider than the height of the drum.

Steps:

1. Sew the long edges of the long strip cloth and the rectangular cloth, and sew a pleat every other section. The pleat spacing and folding depth should be controlled by yourself.

2. Wrap the sewed two pieces of cloth around the drum inward, and then spread the circular cloth on it, which is also the color inward, and sew a circle. Then sew the edges of the drum, that is, the two sides of the rectangular cloth.

3. Finally, sew a ring about one centimeter on the excess part of the drum, and be careful not to sew two joints. Turn the whole condom upside down, put the suit on the coat, put a hard rope on the ring at the bottom, close it and fasten it, and hide the extra head inside. Such a beautiful paper bench will be done!