Since your refrigerator is artificially defrosted, it is best to defrost it every 1 month and a half in summer. After the power is cut off, take out the drawer in the refrigerator, open the door, wipe the ice inside after melting, and use it after the power is turned on!

In addition, if your refrigerator is not tightly sealed, it is easy to freeze. First, loosen the screw that fixes the door sealing strip, put white rubber under the gap of the sealing strip, and then tighten the screw. If the door seal is not tight due to the deformation of the sealing strip, you can blow the deformed part with an electric hair dryer (the blowing time should not be too long) or remove it and scald it with hot water to make it soft and plastic. After installation, it can ensure a firm seal and increase the heat preservation effect! !

The overflow in the refrigerator should be caused by the condensed water not being discharged. There is a small hole (near the sink) in the freezer of your refrigerator. You can poke it down with a cord about 1.5 meters!

Open a few small screws at the bottom of the back of the refrigerator, and you can see that the condensed water in the water pipes and pipes will flow into the water tray above the compressor. Usually, when the compressor heats up, it will evaporate the water.

The reasons why the refrigerator freezes are: 1: The defrosting timer is broken. 2. The defrosting electric heating tube is damaged. 3: The refrigerator fan is broken. 4: The door seal is not good.

5: Too much or too hot water. 6. Fluorine deficiency

In addition, how to use the refrigerator thermostat In the process of using the refrigerator, its working time and power consumption are greatly affected by the ambient temperature, so we need to choose different gears to use in different seasons. Refrigerator thermostat should be turned on at low level in summer and at high level in winter. When the ambient temperature is high in summer, it should be used in weak gear 2 and 3, and when the ambient temperature is low in winter, it should be used in strong gear 4 and 5. The reason is that the ambient temperature is high in summer (up to 30℃). If the temperature in the freezer is set at a high level (4, 5), it will reach below-18℃, so the temperature difference between inside and outside is large, so the temperature in the freezer drops every time. If you change to the weak gear (2nd gear and 3rd gear) at this time, you will find that the start-up time is obviously shortened, the compressor wear is reduced and the service life is prolonged. Therefore, when it is hot in summer, the temperature control will be adjusted to a weak level. When the ambient temperature is low in winter, if the thermostat is still set at a weak position and the temperature difference between inside and outside is small, it will be difficult for the compressor to start, and the refrigerator with single refrigeration system may be frozen in the freezing room.

Remarks: Clean your drain pipe and water tray properly, which may be because there is too much water.