Spare tools: thread and needle in the same color as sweater.

1. Put the broken thread on the reverse side first, and then tie a knot to prevent the thread from breaking again.

2. Then go back to the front and fix the needle from the thread end of the rightmost hole.

3. After the bottom line is tightened, the needle goes back to the top to pick two needles, and then continues to pick two needles at the bottom.

4. By analogy, repeat two stitches up and down until all the holes are stitched.

5. Finally, we must pay attention to closing the needle on the reverse side and tying the thread on the reverse side. After fixing, the maintenance work is completed.

Extended data:

Matters needing attention in daily maintenance

1, before washing the sweater, you should first take off the dust on the sweater, soak the sweater in cold water 10 ~ 20 minutes, take it out, squeeze out the water, put it into the washing powder solution or soap chip solution, gently rub the sweater, and then rinse it with clear water. In order to ensure the color of wool, 2% acetic acid can be dripped into water (vinegar can also be eaten) to neutralize the remaining soap on the sweater.

After washing, squeeze the water out of the sweater, stop, put it in a net bag, hang the sweater in a ventilated place to dry, and don't wring it out or expose it.

2. Washing the sweater (thread) with tea leaves can not only clean the dust on the sweater, but also make the wool not fade and prolong the service life.

The method of washing the sweater is: use a pot of boiling water, put in a proper amount of tea leaves, filter out the tea leaves after the tea leaves are soaked thoroughly and cooled, soak the sweater (thread) in tea for 15 minutes, then gently rub it for several times, then rinse it with clear water, squeeze out the water and shake it evenly, and the wool can be directly placed in the shade to dry; In order to prevent the sweater from deforming, put it in a net bag and hang it in the shade to dry.