Cashmere, which grows in the outer cortex of goats, is a thin layer of fine hair covering the roots of goat coarse hair and belongs to rare special animal fibers. Cashmere is very precious, not only because of its scarce output, but also because of its excellent quality and characteristics, which is incomparable to all textile raw materials available to human beings at present. In trading, the price is determined in grams, so it is also called "soft gold".
To knit a good cashmere sweater, it is very important to choose a good cashmere line. So how to bid farewell to the quality of cashmere line?
Skills to identify cashmere line 1:
Take a thread, gently pull it and tear off a piece of wool, just like pulling cotton, which means it is cashmere; If you pull the wool tightly, you need to work hard, and you also have the feeling of pulling cotton, usually wool; If it is stretchable, it still feels like cutting your hand. Chemical fiber is beyond doubt.
Cashmere line Skills for Identifying Cashmere II:
Burn wool vertically from the bottom with a lighter. When ignited, it will leave the fire source and will soon go out. It will become powder when pinched, so this is wool.
But after ignition, the flame still burns up along the wool until the wool burns completely, so this is cashmere cashmere line.
Cashmere line Skills for Identifying Cashmere 3:
You can smell it when you put it on your nose. Good cashmere has goat smell, which will be fully reflected when cashmere line fabric is ironed. The stronger the smell, the better the wool, the higher the grade and the higher the price.
Cashmere line Skills 4 for Identifying Cashmere:
The cashmere content in cashmere line is above 30%, and the lowest market price of 30 cashmere is about 400 yuan/kg. If it's lower than 200 yuan, don't expect to buy the real thing. The principle of value for money will never go out of date.
Cashmere and wool hand-woven clothes should also pay attention to choosing the right needle, not too thick or too thin, depending on how many strands of yarn the needle is, the density of the woven clothes is too loose and the clothes are loose and deformed; If the needle is thin, the density of the woven clothes is too tight, which leads to poor hand feeling and uncomfortable wearing.
The cashmere sweater you asked is getting longer before it is finished. Probably the choice of needle. The thread is too thin and the needle is too thick. I hope I can help you.
The thick thread of needles was thin, or the number was inaccurate at that time, because cashmere line was elastic. If the lining is straightened and retracted, it will cause inaccuracy. Some cashmere line still have the possibility of shrinking or enlarging when washing. You can consult the customer service who sells cashmere line and explain this situation in detail. If the customer service does not understand, you can ask him to consult the manufacturer for details. Do you want to reserve a printed copy?
Hello, I'm glad to answer your question.
First of all, you should know something about cashmere.
The bigger the sweater, the bigger it is because the material of the clothes is different. The more times you wear it, the bigger it will be! Wearing a small sweater is because the sweater shrinks and can't be handled well during processing. Before washing clothes at home, you can add some salt water to dry the clothes to avoid shrinkage or big problems!
Wired tweed, labor cloth, colored plaid velvet, bed sheet cloth, youth cloth, etc. Used as decorative cloth for clothing and furniture. Since the 1960s, with the development of chemical fiber blended fabrics, the varieties of yarn-dyed fabrics have been increasing, including polyester-cotton high count poplin and polyester-cotton medium tweed. First, the concept of colored fabric 1, full-color weaving: both warp and weft have dyed or partially dyed yarns (or there are several colored yarns interwoven with white yarns in the fabric). 2. Semi-color weaving: warp or weft is dyed or partially dyed. 3. White cloth: cloth woven with undyed yarn-grey cloth. 4. Comparison between white woven and yarn-dyed products: The color fastness of yarn-dyed yarn is higher than that after white woven. Second, the reason why the fabrics are full-color woven and semi-color woven 1. Full-color weaving: a In order to obtain the effect of different colors-the same raw material can't be treated after being dyed in different colors, but it can be woven in color. B requirements for color fastness and shade-yarn-dyed products have good color fastness and shade. C. requirements for layering-it is required to obtain a good layering. 2. Semi-color weaving: Different warp and weft raw materials-different warp and weft raw materials have different requirements for dyeing performance, so semi-color weaving can be used to reduce costs and increase fancy.
So, here are some ways:
The fiber structure of woolen clothing is looser than other fabrics, so it is easy to deform. This is the problem of silk clothing itself. Mild deformation can be recovered by ironing and stretching, while severe deformation cannot be recovered.
Animal hair is protein fiber, which is easy to shrink. It should be sent to a professional washing shop for dry cleaning.
When the wool fabric becomes dirty, it must be washed immediately to avoid leaving traces. The longer the stain stays on it, the less likely it is to be washed off; And after a long time, stains will penetrate into the fibers, and it is inevitable to rub hard when cleaning, which is more likely to cause damage to clothes.
For local slight stains, try to gently wipe the wool surface with a towel dipped in neutral laundry detergent or special detergent solution for silk cotton. After removing the stain, dip a clean towel in water and remove the detergent residue in the same way. Can be repeated several times. Try not to soak the leather board during operation, and dry it in the shade in time.
If it can be cleaned, pay attention to the following points during daily cleaning:
1, if washing, use alkali-resistant, neutral and enzyme-free detergent, especially wool detergent. If you use a washing machine, you should use a drum washing machine and choose a soft program. If you wash it by hand, it is best to rub it gently, not with a washboard;
2. Wool fabric will shrink and deform in water solution above 30 degrees. Gu clothes should be soaked in cold water for a short time, and the washing temperature should not exceed 40 degrees. Gently rub and wash, not rub hard. Machine washing must use laundry bags, choose light gear. Dark colors generally fade easily.
3. Squeeze and wash, avoid wringing, squeeze out water, spread it evenly and dry it in the shade or fold it in the shade; Wet plastic surgery or semi-dry plastic surgery can remove wrinkles and avoid sun exposure;
4. Softening agents should be used to keep soft hand feeling and antistatic performance.
5. Do not use chlorine-containing bleaching solution, but use oxygen-containing color to bleach.
Attention should be paid to when storing:
1, avoid contact with sharp, rough and strongly alkaline articles;
2. Select a cool and ventilated place to cool down and dry before collecting;
3. During the collection, the cabinet should be opened regularly, ventilated and kept dry;
4, high temperature and humid season, should be aired several times to prevent mildew.
I'm Sister Yuan. I'm glad to answer this question for you.
Cashmere line's knitted clothes haven't been knitted yet, and they have grown an inch. That's because the needle model is wrong, the needle and thread are fine, and cashmere line is elastic. In addition, everyone's knitting method is different, and the fingers are too loose when paying off, which will lead to loose clothes. At this time, if the clothes are not finished in a short time, they will become longer and longer.
I suggest that when you are knitting, your letting-off finger should tighten the thread a little, so that the knitted clothes will be smooth, not longer and longer, and the clothes will be very stylish.
The above is my answer, I hope it will help you.
First, the definition of cashmere line
Cashmere line uses cashmere as raw material for knitting needles. The raw material of cashmere line is goat.
Wool, and wool and wool have a wide range of applications, which can be any raw material, including cotton, wool and nitrile.
Nylon or mohair, etc.
With the continuous improvement of people's living standards, we found that there is a kind of wool that is more warm and heavy.
Much lighter than wool, this is cashmere line. Cashmere, known as fiber gem or soft gold, is excellent because of its advantages.
Different physical properties naturally become the queen of animal fibers, and her value also makes ordinary animal fibers such as wool.
Beyond the dust! Perhaps for this reason, cashmere line has not become the mainstream of market consumption. cashmere
The price of thread is higher than that of ordinary wool, but the knitted cashmere garment looks very noble and super warm.
It is three times that of ordinary wool and is very popular with the public. As people get to know cashmere line better, there will be
More and more people began to like cashmere line.
Note: Tips on cashmere knowledge
Cashmere is a rare special animal fiber in the world, and it is also a high-grade raw material in textile industry, which is well known by people.
For "fiber diamonds" and "soft gold". Wool fibers cut from goats are called cashmere.
Cashmere for short. It is a fine and rich layer that goats grow on the roots of goat hair to resist the cold of winter.
Thick fluff grows when it is cold in winter to resist the cold, and falls off when it is warm in spring, naturally adapting to the climate. climate
The colder the weather, the richer the cashmere and the longer the fiber. [For more information about cashmere, please refer to the Complete Book of Cashmere Knowledge]
Second, the production principle of cashmere line
(1), impurity removal
Spinning is the science of processing textile short fibers into yarns, which are generally composed of many long and short fibers.
Short fibers with different degrees are spliced, and some are spliced by very long continuous monofilaments. exist
In the process of spinning, impurities need to be removed first, that is, the raw materials are preliminarily processed, which is also called the preparation of spinning raw materials.
Different kinds of raw materials, different kinds and properties of impurities, and different processing methods and processes. The beginning of raw materials
Step processing methods mainly include physical methods (such as cotton ginning) and chemical methods (such as hemp degumming and silk scouring)
And physical and chemical methods (such as washing, weeding and carbonization of wool).
(2) release
It is necessary to change the block fiber into a single fiber state, remove the transverse connection of fiber raw materials, and establish a firm longitudinal connection from end to end. The former is called fiber release and the latter is called fiber collection. Loose fiber is to completely remove the transverse connection between fibers, but the damage of fibers must be reduced as much as possible. The collection of fibers is to re-establish the orderly longitudinal connection of released fibers, which is continuous, and the fibers in the collection should be evenly distributed and have a certain linear density and strength. Fiber assembly also needs to increase a certain twist. The assembly process is not completed at one time, and it can only be completed through carding, drafting and twisting.
(3) Opening remarks
Opening is to tear large pieces of fiber into small bundles. Broadly speaking, the degumming of hemp is also an opening. With the opening, the connection between fibers and impurities is weakened, so that impurities are removed and fibers are mixed. Opening and removing impurities are not completed at one time, but are gradually realized through the reasonable configuration of tearing, beating and separating.
(4) carding
The carding function is to further loosen the small pieces and bundles of fibers into a single state through a large number of dense carding needles on the carding machine, thus further improving the loosening of fibers. After carding, the transverse connection between fibers is basically eliminated, and impurity removal and mixing are more sufficient. However, a large number of fibers are bent and have hooks, and there is still a certain horizontal connection between each fiber.
(5) carding
The carding function of the comber is to comb the two ends of the fiber more carefully under the clamping state. Comber processing can eliminate short fibers and fine impurities below a certain length, and promote fibers to be more parallel and straight. Chemical fiber is generally not processed by combing machine because of its neat length, less impurities and good straight and parallel state.
(6) Drafting
The drafting process of combed sliver is called drawing. It lays a foundation for firmly establishing the regular end-to-end connection relationship between fibers. However, drafting will bring uneven yarn short joints, so it is necessary to configure reasonable drafting device and process parameters.
(7), twist
Torsion is to twist the whisker around its own axis, so that the fibers parallel to the axial direction of the whisker are spiral, thus generating radial pressure to fix the longitudinal connection between the fibers.
(8), winding
Winding a semi-finished product or finished product into a certain form to facilitate the storage, transportation and processing of the next process is called winding. The winding process should be carried out continuously on the basis of not affecting the output and quality of products, and efforts should be made to realize continuous production among all processes and minimize the quality problems caused by the winding process. In short, the spinning process generally includes the functions of raw material preparation, opening, carding, impurity removal, mixing, drafting, merging, twisting and winding, and some functions are realized by repeated times.
So the manufacturing process, storage environment, raw materials and so on all determine the quality.
Needless to say, you didn't buy a real cashmere line!
It's my pleasure to answer your question. I am willing to answer your question. My company is Ordos Group, which has the most say. Although I am not engaged in production, I know a thing or two about hand-woven cashmere garments, and I am not as sophisticated as sophisticated machinery and equipment. When knitting by hand, there are bound to be loose and tight times, and it is normal for them to become longer. Actually, if it's for my own pleasure, I suggest knitting something simple.