Elliptical plates can be processed with maximum thickness at the midpoint and right angle at the longest point! Processing technology There are four main production lines for granite processing: standard plate production line, thin plate production line and coarse decorative plate. Raw marble has light weight, high strength, thin thickness, good corrosion resistance, pollution resistance and good machinability, and can be made into an arc. There are four main types of production lines for curved granite processing: standard plate production line, thin plate production line, rough decorative plate production line and special-shaped plate production line. Stone is light in weight, high in strength, thin in thickness, corrosion-resistant and pollution-resistant, and it is made into an arc compared with machinability. Better take them separately. It is easy to damage the stone during installation, and excessive glue will increase the comprehensive cost of processing groove width. Therefore, the board can be hung at any angle using slight techniques, such as diamond, mouth post, semicircle, triangle, arc, line, Xiamen line, angle, head and abnormity. Three arc-shaped marbles are one segment, and a general cylinder is divided into two segments. Three quarters. A section is generally 0.8- 1. 1 m. Stone and stone materials include general red, Indian red, Sophora japonica green and so on. Prices vary. Some of them were bought at the stone market.