1, fold in half, but not compact, leaving only traces of the middle point. Then fold both sides in half to the middle point. Fold it in half again, divide it into eight parts and turn it over. Fold down according to the crease, fold back according to the crease, leave the crease, and then open it, and the same is true for the other side.
2. The obtained crease map, aggregated according to the peak-valley line, is a simple snake belly fold. Turn it over, the vertex should be folded down as far as possible, and the bottom should be folded up, with no reference point. Vertex folds down, there is no reference point, handle two ears, and fold back.
3, segment folding, inward folding, ears open, the same as other rabbit ears. Do the same thing on the other side. Then turn it over, align the bottom edge with the reference point upwards, fold it in half, and open it according to the fold line.
4. Fold the peak to the back of the rabbit's head, fold the first layer in, pull it, like this, then turn it over according to the folding line, and pull the paper at the back. Do the same on the other side, and then finalize the design.
5. Fold the red cardboard diagonally, turn it over, turn the vertex to the center, fold both sides inward at the midpoint, and then fold it again at the midpoint. Pull out the inner part, leave the edge 1 cm wide and fold it, and the other side is the same. After spreading it out, fold it according to the crease, and the other side is the same.
6. Turn it over, align it with the bottom, fold it back and put away your tail. Then fold the rabbit's face and ears, seal the opening, and finally draw the rabbit's eyes and mouth.