1 Fold out the basic type of paper crane first. As shown in the figure, fold the paper diagonally, then fold it in half, and then open the triangular pocket to flatten it, and the back is also flat.

2

Pull down the upper corner, then fold it in half toward the center along the bisector of the corner and flatten it, as well as the back, so that the basic type of paper crane needed in the following content will be folded.

three

Start breaking leaves. As shown in the figure, the upper corner is folded upwards to form Figure 2, then folded towards the middle along the crease, unfolded as shown in Figure 5, and contracted inward along the crease, and both sides are operated in the same way, and finally Figure 8 is formed.

four

Fold the lower two corners up along the crease, then spread the other side up to form the number 3.

five

After turning the paper over, fold the corner down as shown in Figure 2, then fold the corner up by 90 degrees as shown in Figure 3, then spread and flatten the place indicated by the arrow as shown in Figure 4, and then open it along the arrow. Do the same operation on both sides.

six

Flatten the 90-degree angle upwards, and pay attention to pull the middle two sides apart along the arrow, then fold the bisector of the lower corner in half and flatten it at the same time.

seven

Spread the paper along the crease, then fold it up, then fold it in half inward along the crease, then fold it down, and finally fold the corner in half to the middle, and the top will naturally be flat.

eight

This is the front of the leaf, and then it can be adjusted according to the shape of the leaf to be folded, as shown on the right.

1 prepare a piece of hand-rubbed paper with green leaves on it, the size of which is determined by the flowers themselves. What I provide is the leaf tutorial of Spring Rose IV. You might as well take a look and learn.

2 fold in half diagonally, as shown in the figure.

3 find one side and fold it down, as shown in the figure.

The other end is also folded down, as shown in the figure.

5 the same method, the other side of the same operation, as shown in figure.

6. Shaping the reverse side, pinching where there are sharp corners, smooth and natural, shaping and edging, as shown in the figure.

7 Turn to the front, buckle the leaves with your nails and buckle the veins of the leaves, as shown in the figure.

8 pinch the leaf root for later assembly, as shown in the figure.

Finally, assemble the leaves on the flower stem. This is the final renderings. Let's have a look.