2. Operators must strictly implement the "Cross Operation Policy" and do a good job in maintenance.
3, steel processing machinery operators must be trained by the relevant departments and obtain a certificate before they can take up their posts.
4. Before using the equipment, it is necessary to check whether the working parts such as blades, straightening blocks, forming shafts or working disks are installed correctly, whether there are cracks and whether the fixing screws are tightened.
5. The protective covers of all transmission parts must be complete and effective.
6. Before working, you must check whether the power supply wiring is correct, whether the insulation of all electrical components is good, and whether the fuselage has reliable protective grounding or protective zero connection.
7. Before the equipment is used, it must be put into trial operation with empty car, and it can be officially started only after it is confirmed that there is no abnormality.
8, in the process of mechanical operation, adjustment, maintenance and cleaning are prohibited.
9, it is forbidden to process (such as cutting, straightening, bending, etc.) steel bars exceeding the specified specifications or excellent steel bars.
1. When using the straightening machine, a steel pipe with a length of about one meter should be installed at the front of the guide cylinder. The straightened steel bar should pass through the steel pipe first, and then pass through the guide cylinder and straightening cylinder to prevent each plate of steel bar from popping up when the straightening is finished.
11. When using the steel bar cutter, the steel bar must be held tightly. When the movable blade retreats, the steel bar should be sent to the knife edge. In case of short material, it is necessary to clamp the feeding with pliers.
12. It is forbidden to process non-straight steel bars on the bending machine to prevent safety accidents.
13. When processing a long steel bar, special personnel should be assigned to help the steel bar. The personnel who help the steel bar should coordinate with the mechanical personnel and listen to their instructions. They are not allowed to pull or drag at will.
14. Scrape iron and steel foam on the rack shall not be wiped by hand or blown by mouth to avoid scratching the skin or splashing into eyes.
15. Semi-finished products that have been cut off or bent should be packed neatly to prevent individual new incisions from protruding and scratching the skin. After the work is finished every day, the cut broken heads must be cleaned up, and the brake box should be locked before leaving.
for more information about the engineering/service/procurement bidding, and to improve the winning rate, you can click on the bottom of official website Customer Service for free consultation:/#/? source=bdzd