HP Notebook g6 Disassembly Diagram HP g6 Disassembly Tutorial Complete Solution-Remove the Bottom Screw
1. First, remove all screws on the back of HP g6. Be sure to code the screws and don't put them anywhere. Be sure to remember the position of the different screws. Remove the hard disk cover. After that cover, there are still three screws in it, so we can take down the motherboard.
2. The two screws at the bottom of the 2.HP g6 battery slot are keyboard screws, and the one at the bottom is the screw of the optical drive. After unscrewing the screw that fixes the optical drive, the optical drive can be removed. After the screw is removed, you need to pry open the shell and pry it slowly. Don't worry. There are no nails, you can use tools.
Complete solution of HP g6 disassembly tutorial-keyboard disassembly
3. Then turn the laptop HP g6 to the front, and then prepare to disassemble its keyboard. Here we need to press the button on the HP g6 keyboard.
This button can be pushed back and forth. After the keyboard is removed, you can see it yourself. Every laptop keyboard will have this buckle. When we disassemble the machine, we need to push off the five buckles at ESC, F4, F8, F 12 and Del. When all five buckles are pushed down, the upper side of the keyboard will be slightly tilted (the keyboard screws on the back must be removed, otherwise it will not tilt).
HP g6 Removal Tutorial Complete Solution-Cable Removal
5. It should be noted here that the Tab, Pg and Up keys have a fixed button respectively. At this time, we just need to exert a little force and tilt it, and the keyboard will come down. Be careful not to move too much, the line is still connected behind the keyboard. Don't break the cable.
6. The keyboard cable of 6.HP g6 is buckled. Just button it with your nails, just like opening the lid of shampoo, and the keyboard line will come out. After the keyboard is removed, two cables are the same as the keyboard cable. Buckle it.
HP g6 Disassembly Tutorial Complete Solution-Motherboard Disassembly
7. You can't take away the shell of HP g6 at this time. Turn it over and look at the back. There are two wires connected together. It's on the right side of the hard drive. With a little force, it will come off, just like the buttons on our clothes.
8. When you take the HP g6 motherboard, you should also pay attention to the cable connection in the upper left and lower right. ? The red line is the position of the screw. The blue line is the power supply. Nothing is fixed. Just take it out, but it's also difficult. The yellow wire is connected to the monitor. The wire drawing method here is different from the previous one, so you need to hold both sides hard.