Dragon spit beads will consume a lot of nutrients after flowering. First of all, it is necessary to cut off its stem in time, then cut off the bud at its upper end, then cut off the long branches about 10cm, cut off the withered, withered and diseased branches, and finally prune them. Don't trim too much, otherwise it will resist the normal growth of dragon figure beads.

Pruning method of Dragon Tuzhu after flowering 1, cutting off the flower stem.

Bambusa longtuensis is a climbing evergreen shrub. Whenever it blooms, its branches and leaves will appear messy, and it will consume a lot of nutrients in the soil. At this time, it is necessary to cut off the stem and the remaining flowers in time to avoid unnecessary nutrient consumption.

2, coring processing

At this time, you can remove all the buds at the top of the dragon spit bead, and then cut off the branches that are too long at the top by about 10cm, which can control the growth of the dragon spit bead at the high end, promote it to sprout too many shoots, and let it bloom more flowers next time.

3, plastic pruning

Usually, in the flower pruning video of Longtu bamboo, the withered, withered and diseased branches must be cut off and then pruned, which can reduce the consumption of soil nutrients, increase the ornamental value of Longtu bamboo and make it grow well.

4, disinfection treatment

Pruning Dendrocalamus latiflorus after flowering should not be too heavy, otherwise it will hinder its growth. Just trim it properly and spray carbendazim properly to avoid the wound being infected by bacteria and promote the wound healing. Pruned branches can also be cut and propagated.