1. Open the edge banding machine, check whether the position of the edge banding machine is correct, and adjust it if necessary.
2. Adjust the pressure of the dresser so that the dresser is in close contact with the surface of the plate. Pressure adjustment should be properly adjusted according to the thickness and hardness of the plate.
3. Adjust the cutting depth of the dresser. The cutting depth should be adjusted according to the thickness of the plate. Generally speaking, thicker plates need deeper cutting depth, and thinner plates need shallower cutting depth.
4. Open the edge banding machine, check whether the angle of the dresser is correct, and make adjustments if necessary.
5. Adjust the angle of the dresser. Generally speaking, the angle of dresser should be perpendicular to the board surface to ensure the best dressing effect.
6. Adjust the rotating speed of the dresser. Too fast rotation speed may lead to unsatisfactory dressing effect, while too slow rotation speed will affect work efficiency. Therefore, it is necessary to make appropriate adjustments according to the actual situation.
Matters needing attention in adjusting and trimming the edger are as follows:
1. After edge sealing, if the edge sealing tape is torn off, it is found that the adhesive layer is too thin and the edge sealing tape is not sticky enough, so as to increase the gap between the guide rail and the plate; If the coating is uneven, reduce the gap.
If the board is not completely attached to the edge sealing tape, it means that the pressure wheel is not perpendicular to the edge surface of the board to be sealed. In this case, it is necessary to adjust the screws and try many times to carefully observe whether there is a gap between the pressure plate and the plate.
2. Adjust the counter on the laminating mechanism when replacing the edge banding tapes with different thicknesses. Adjustment method: If the board is not completely attached to the edge sealing belt, it means that the pressing wheel is not perpendicular to the edge surface of the board to be sealed. In this case, it is necessary to adjust the screws and try many times to carefully observe whether there is a gap between the pressure plate and the plate.
3. If the trimming knife is damaged, it should be replaced in time. Otherwise, unbalanced fine adjustment will cause strong vibration of the motor, resulting in damage to many parts. Note: When installing a new edging knife, pay special attention to the relative relationship between the rotation direction of the motor and the rotation direction of the edging knife. If the edging knife is installed backwards, it is easy to damage the edging knife.
4. Pay attention to the adjustment of gluing amount: if the gluing is uneven or too thin after edge sealing, it is necessary to adjust the gluing amount appropriately.
5. Pay attention to the adjustment of glue output: according to the thickness of different plates and edge sealing tapes, the glue output needs to be adjusted to achieve the best edge sealing effect.
6. Pay attention to the adjustment of the guide rail: the function of the guide rail is to guide the edge sealing tape to stick to the board smoothly. If the gap between the guide rail and the plate is too large or too small, it will affect the edge sealing effect.
7. Pay attention to the adjustment of tape feeding: when replacing edge banding tapes with different widths and thicknesses, the automatic tape feeding must be adjusted. Pay attention to ensure that the front end of the edge sealing belt passes through the feed pulley and does not exceed the cutter, otherwise some mechanisms will be damaged when sealing the plate.
8. Pay attention to the adjustment of the pinch roller and pinch roller: when replacing the edge banding tapes with different thicknesses, adjust the counters on the pinch roller and pinch roller mechanism. At the same time, pay attention to observe whether there is a gap between the pressure wheel and the board. If so, you need to try it several times by adjusting the screw.