Because of its harsh environment and heavy dust, some users are not properly maintained, and various problems often occur in operation. Generally speaking, cone crusher should pay attention to the following problems in operation to ensure the normal operation of the machine. First, how to maintain the cone crusher during operation?

1. In the work of cone crusher, the feeding should be uniform. If the feeding is not uniform, the production capacity will decrease, the product granularity will be too large, the spring will move frequently, the pressure on the bowl bearing will be high, and the power consumption will increase.

2. There should be an iron remover to prevent the cavity iron from being broken. If iron is removed frequently, the shaft may be broken. Production at full capacity, otherwise the product granularity is too coarse.

3. The crushing rate in the sand production line should be reasonable to give full play to the efficiency of the cone crusher.

4. The spring pressure should not be too tight. If the pressure is too high, the shaft will break. If the pressure is too low, the spring will jump frequently, which will affect the normal work of the cone crusher and the particle size of the product will become coarse.

5. The temperature of lubricating oil should not be too high or too low, otherwise it will affect the operation of the machine. Lubricating oil should be changed frequently, not too dirty. Too dirty will accelerate the wear of gears, bowl shoes and shaft sleeves, and wear the shaft sleeves to death.

6. The installation of the drive belt should not be too tight, otherwise the drive shaft will rotate inflexibly or the fracture cannot be too loose, otherwise the cone crusher will be blocked.

7. The feed should not be too wet and sticky, and the fine particles should not be too big, otherwise it will cause traffic congestion. Sediments at the discharge port of cone crusher can also cause congestion.

there will be some problems in the actual operation and use of cone crusher, and the problems are different, so different solutions should be taken according to the specific situation. Here are just some situations that are often seen in actual operation.