2. The differential mode of subsection adjustment is divided into upper mode and lower mode. Align the centers of the upper and lower molds and adjust the gap.
3. Confirm the blocking direction and process flow before and after, and switch according to the conditioning switch. Put the workpiece in the middle of the hydraulic bending machine workbench for pressure measurement.
4. The upper die device is the same as the common bending machine, but it should be noted that the die core should be placed on the surface of the operator and the lower die device should be placed on the inner side of the bending machine.
5. General rear gear adjustment includes electric quick adjustment and manual fine adjustment, and the method is the same as that of shearing machine. When the foot switch starts to twist, releasing the foot will stop working, and the time to continue pedaling will continue.
6. After piercing the washer, the fastening screw must be determined. At the same time, the spacing between the die base and the die core in different directions of the upper and lower dies is measured randomly with calipers to ensure that all spacing scales are consistent.