Knowing the cause of nose hypertrophy, how to improve nose hypertrophy?
I often tell beauty seekers that we can only change your nose from L to M, or from XL to L, and it is impossible to directly change it from L to S. It is difficult for us to change from one number to a very small number and from one extreme to the other. So plastic surgery is carried out on a certain basis. For a big nose, analyze it first. If it is fat nose hypertrophy, remove some adipose tissue first.
If it is cartilaginous, it is necessary to sew up his cartilage, fold it up, or get together in the middle. If he has fat and cartilage separation at the same time, what we need is a combination of the two methods. Generally speaking, if his cartilage is located on the outside, that is to say, his cartilage is separated greatly. In this case, when we do some nose contraction, we may add some supporting cartilage in the middle, gather his alar cartilage in the middle, add a protrusion of the tip of the nose, and re-create a new nose, which will turn the big nose into a small nose.
In the process of rhinoplasty, we usually use open incision and make a horizontal incision from the position of nasal columella. This incision needs to completely expose or open the nose. Only in this way can the nose be reduced well. For beauty seekers, they should know or be psychologically prepared before the operation. In the future, this place may leave a mark or scar. Generally speaking, by 1-3 months, this scar is not obvious. Beauty seekers don't have to be too nervous about this scar.
To choose good hospitals and experienced hospitals, remember not to choose beauty salons and clinics.
I hope the answer can help you!
It depends on the type of nose hypertrophy.
Meat nose
If the nose hypertrophy is due to the opening of the alar foot, but the skin tissue is relatively thin, then after suturing the cartilage, you can see that the nose is obviously reduced. Folding suture of alar cartilage
If the alar cartilage is poorly developed, the nasal tip is low and the alar leans forward, then we can also use autologous cartilage to "reconstruct the anatomical structure of the nasal tip". In this way, the nose is not only small, but also convex, and the nose will be much more delicate.
If the alar is thick and wide, then we can consider removing some alar tissues and reducing the alar to achieve the effect of reducing the alar.
If the nose is due to fat and soft tissue hypertrophy, the whole nose is big and round, and it is difficult to shrink. It is generally not recommended to thin the fleshy nose soft tissue, because it may lead to more serious subcutaneous soft tissue hyperplasia, so the result is that the nose is not smaller, but larger.
The usual practice is to reconstruct the nasal tip through anatomy. The effect of gathering cartilage, raising the tip of nose and narrowing nose is still good. It's like a fat man of the same weight. If it is raised, it will look thin. What kind of nose is enlarged and what kind of nose reduction method is adopted can only be determined by face-to-face diagnosis.
Hello, I'm Wang.
I do rhinoplasty, mainly to remove the hypertrophic alar cartilage, not the soft tissue. However, if you have hypertrophy of soft tissue, but the alar cartilage is underdeveloped, you need to consider the control of anatomical level if you want to remove some soft tissue during surgery.
Because the truth of skin hyperplasia is mainly collagen fiber hyperplasia in the process of self-healing after subcutaneous dermal injury. Therefore, as long as the dermis layer of the skin is not destroyed, only the subcutaneous fascia layer is partially removed, which will not cause obvious hyperplasia.
Diffusion is inevitable, but the degree of diffusion is controllable.
Doctors who pass the technical test will control the degree of proliferation to the greatest extent. According to my clinical case, no matter how the nose proliferates, it will not be bigger than the original one, and it also has obvious effect to treat hyperplastic tissue with scar needle after operation.
Many people are not very satisfied with their nose shape. Too big a nose will affect the whole five senses and appear uncoordinated. What can be done to change it? In fact, it can be improved by nose plastic surgery.
Nose reduction surgery:
1. Make a nostril margin incision along the medial alar cartilage and the anterior edge of the lateral foot;
2. After incision, separate the skin from the alar cartilage below;
3. Trim the fat structure on the surface of alar cartilage, and then remove most of the upper and lateral parts of alar cartilage, leaving only the ""-shaped cartilage in the middle and edge.
4. suture the incision.
Although nose plastic surgery is not a particularly big operation, you should choose a regular plastic surgery hospital and experienced doctors, and don't be greedy and cheap.
Last week, the military adviser wrote an article about the list of annoying noses, which attracted many readers' attention. Strategists realize that so many friends are deeply troubled by nose problems ... and many people have ugly noses, not because their noses are high, but because their noses are enlarged. Especially for such a round nose, basically not many people can hold it, and cosmetic modification is only a "temporary solution". So many fans asked the strategist, what should I do if I encounter such a big nose? A wide and thick nose always gives people a rude and dull feeling. The nose is too big to be laughed at as a pig's nose. So, today we will come to Hong Kong to discuss the problem of nose hypertrophy.
First, where is the nose? Second, then the point is, what is the cause of nose hypertrophy? How to solve it? Some people think that a big nose means more meat, so just cut it off. Is that really the case?
There are three types of nose hypertrophy: one is cartilage stent hypertrophy, the other is soft tissue hypertrophy, and the third is cartilage and soft tissue hypertrophy. Most of us yellow people will have moderate nose hypertrophy.
The traditional solution is to thin the thick soft tissue. However, with the development of medical technology, it is recommended to use autologous cartilage to rebuild the cartilage scaffold of nasal tip.
This can lengthen the length of the nose, raise the nose tip, adjust the appearance of the nose tip and the lack of soft triangle or pinch the nose tip, narrow the nose tip from the inside out, make the nose naturally smaller, and avoid postoperative complications such as soft tissue hyperplasia caused by soft tissue thinning.
Many female patients want their noses to be beautiful. Because the nose is an important part of our five senses, it will make our face more vivid and change the curve on the side of our face. Some patients have bigger noses and feel distressed. They often ask how to make their noses smaller.
We know that the tip of the nose, which we often call the nose, is composed of cartilage tissue below and skin tissue above. During the operation, the patient's cartilage tissue should be considered first. For some patients with more cartilage, we can change the shape of the patient's nose through cartilage plastic surgery. For some patients who are still dissatisfied with the shape of the nose after the cartilage tissue changes, we can improve the shape of our nose by using some artificial materials or autologous cartilage, such as auricle cartilage, so as to make it smaller and more delicate.
It can be polished with a grinding wheel.
First take a deep breath, then hold the nasal cavity with your thumb and forefinger.
Push the air out gradually, and then you will feel the exhaled air pressing against your ears and eyes.
After feeling the gas reaching the inner ear, suddenly let go of your fingers and breathe normally for two or three times.
One more time, * * * three times. Do the opposite breathing training.
Breathe out the residual gas in the body first, then hold the nasal cavity with your fingers, and don't breathe or inhale.
Then suddenly loosen your fingers, take a deep breath and do it three times.
Effective methods: With the cooperation of breathing, the maxillary bone and nasal bone are pressed to support the nasal bone. ………………
——————————————————————————
Everyone is so enthusiastic! My skin is very touching. So I decided to choose 50 commentators in the comment column at the bottom of this answer for one-on-one tutoring.
I hope you can get more relevant knowledge through this answer. On the one hand, enriching our knowledge, on the other hand, having an understanding in advance can improve our communication efficiency, on the other hand, it is also a respect for me.
——————————————————————————
Effective methods: With the cooperation of breathing, the maxillary bone and nasal bone are pressed to support the nasal bone. First, I will demonstrate the feasible ways and feasibility of narrowing the alar, raising the bridge of the nose and narrowing the nose through the description of the nasal bone structure.
I believe that after reading it, you will have a systematic understanding, and you will easily distinguish whether the scheme is reliable or not.
Skeleton, muscle and cartilaginous muscle are very soft, while nasal muscle is very thin, and force and stress are generated by pulling between muscles; Cartilage is also soft, and its shape is related to musculoskeletal; Bones are hard, and the mechanical structure is formed by the supporting force and pressure between bones. Therefore, bones play a decisive role in the change of nose shape, and changing the mechanical structure between bones is the basis of everything.
The skeleton of nasal bone nose consists of nasal bone, frontal process of maxilla and frontal bone nose. The surface morphology of the frontal bone nose is: the eyebrow arches on both sides naturally extend to the frontal nasal spine, and the eyebrow arches are raised, and the frontal bone in the center of the eyebrow arch is relatively concave, V-shaped, with a wide opening. The frontal process of maxilla is supported by both sides of the nasal bone and connected with the lateral nasal cartilage below the nasal bone.
The uniqueness of the nasal bone is that it is only supported by other bones and is not oppressed by other bones. Moreover, it is composed of two axisymmetric bones, and its mechanical structure has certain plasticity.
Nasal muscle is divided into two parts-wing and transverse. The transverse process is a muscle that compresses outward from the outside of the nasal bone, and both ends compress the levator alaris and levator labialis of the upper lip. Wings are on both sides of the nose. Nasal muscles have no ability to support nasal bones, but only change with the change of nasal bones. The levator alar muscle of upper lip has no ability to pull the nasal bone, and it also changes with the shape of the nasal bone and maxilla.
Unlike arms and legs, the shape change of nose can be seen through muscle training. Nasal muscles are very thin, and they don't have the ability of self-contraction and relaxation. They only rely on the stress of related muscle groups to exercise. Therefore, it is unrealistic to reduce the alar by changing the shape of muscles. The shape of the nose still needs to be changed by changing the mechanical structure of the bones.
Therefore, for the reduction of the alar, the operation is padding, filling, cutting and grinding, and the supporting structure between the nasal bone and the maxilla is adjusted by external force without surgery.
Nasal cartilage is cartilage, descending muscle of nasal septum and other tissues in the nose, which is supported by maxillary bone under the pressure of nasal bone (the mechanical structure of medial bones such as sieve plate, middle nasal bone, cockscomb, vertical plate, inferior turbinate and plow bone can only be changed by the force of lateral bones). At the same time, its shape is also slightly influenced by the inward force of related muscles. Because a part of the lateral nasal cartilage is pressed under the nasal bone and the upper part of the alar cartilage is pressed under the lateral nasal cartilage, the width of the nose can be reduced and the height can be improved by moving the coronal plane of the nasal bone, squeezing the lateral nasal cartilage and alar cartilage inward and pulling other nasal cartilage inward.
In other words, we can completely press the nasal bone, so that the nose can be non-invasive.
The pyramid shape of the nose is still a pyramid shape. The volume has not changed, but the height has increased and the bottom area has decreased. Visually, the front of the alar is narrowed, the nose is smaller and the nose side is raised.
Is this more attractive than just narrowing your nose? ! At the beginning, part of this action coincides with the action of raising the bridge of the nose that I introduced to you before.
First, put your two hands and four fingers together and separate your thumbs.
The metacarpophalangeal joints of the index finger of both hands are pressed against the maxilla (the corners of the mouth are inclined inward). (red circle)
The interphalangeal joint near the metacarpal joint of both hands is pressed on both sides of the nasal bone. (yellow circle)
Open your mouth slightly, inhale, inhale at the same time, and press the joints of your hands down on the maxilla and nasal bones, as shown in the figure.
After that, it is not the same as raising the bridge of the nose!
After the above-mentioned pressing action lasts for 3-5 seconds, the pressing on the maxilla is released while exhaling, and the fingers and interphalangeal joints squeeze the nose inward and slide down at the same time. The lateral nasal cartilage and alar cartilage are squeezed to the septal cartilage.
As shown above, the purpose is to continuously squeeze the lateral nasal cartilage and alar cartilage on the premise of raising the bridge of the nose and squeezing the wings of the nasal bone. When the nasal bone and related cartilage retract inward, the contraction gives the levator labia a space to converge to the middle. This makes it possible to lift the muscles to the upper lip muscles and tighten them inward! That is to say, for the deformation of the bridge of the nose, the order of action is: the pressure on the nasal bone is a necessary condition, the extrusion of cartilage follows the change of the mechanical structure of the nasal bone, and the contraction of the upper lip muscle solves the filling problem.
When inhaling, the movements of facial muscles work together, and the stress of maxilla is inward. When the lower half of the maxilla is pressed down, the upper half of the maxilla is stressed. When the interphalangeal joint compresses both sides of the nasal bone, it can promote the nasal bone to relax outward. In the process of pressing, no special attention is needed. The knuckles press the levator labia for a certain length. When inhaling, the stress on the bones and the confrontation training of levator labia are always going on. Sliding down while exhaling is another set of antagonistic training to improve the upper lip muscles.
In the whole process, with the change of the stress structure of the bone, the related muscle groups and fascia are slightly adjusted to a new equilibrium state.
2 groups every morning and evening.
Each group 15 times
5~7 seconds each time
It takes less than a few minutes in the morning and evening.
Doing this action for a long time will help relieve the nose pain caused by long-term facial stiffness. It also has the functions of raising the bridge of the nose, adducting the wings of the nose and narrowing the nose!
I hope my answer is helpful to you.