Flexible connectors should be used to connect the encoder shaft of the servo motor with the machine. Do not press hard when installing the connector on the shaft. Even if the connector is used, due to poor installation, it may add a load greater than the allowable load to the shaft, or cause the phenomenon of core shifting, which should be paid special attention to.

Bearing life is related to service conditions, especially affected by bearing load. If the bearing load is less than the specified load, the bearing life can be greatly prolonged.

Do not disassemble the encoder, which will damage the oil-proof and drip-proof performance. Anti-drip products should not be soaked in water for a long time, and should be wiped clean when there is water or oil on the surface. (1) wiring should be done in the power-off state. When the power supply is turned on, if the output line touches the power supply, it will sometimes damage the output circuit.

(2) If the wiring is wrong, it will sometimes damage the internal circuit, so pay full attention to the polarity of the power supply when wiring.

(3) If wiring is conducted in parallel with high-voltage lines and power lines, it will sometimes be damaged due to misoperation caused by induction, so wiring should be conducted separately.

④ When extending the conductor, it should be below 10m. Moreover, due to the distribution ability of wires, the rising and falling time of waveforms will be longer. When there is a problem, use Schmidt ring to shape the waveform.

⑤ In order to avoid induced noise, try to use the shortest wiring distance. When input into integrated circuits, special attention should be paid.

⑥ When extending the conductor, the rising and falling time of the waveform is prolonged due to the influence of conductor resistance and line-to-line capacitance, which is easy to cause interference (crosstalk) between signals, so the conductor with low resistance and line-to-line capacitance (twisted pair, shielded wire) is used.