1. First, fold the paper horizontally and vertically. After unfolding, two criss-crossing creases will be left in the middle of the paper. Next, do a reverse folding at will.

2. Then, on the basis of this rectangular structure, the edge of the center line of the square paper is folded upward, and the width after folding is about 1 cm, which can also be adjusted according to your own needs. Then unfold the origami model, rotate the paper 90 degrees, and fold it in the same way.

3. Fold the origami model twice continuously in a horizontal and vertical way to form a small square. Then fold the corner where the center point of the paper is located upward, and the folded point is at the intersection of the two nearest creases. After folding, expand the origami model.

4. Fold the yellow line into a pre-crease. The remaining three positions in this picture are also folded into pre-creases in the same way.

5. Next, Kawasaki rose-type rotary polymerization is carried out.

6. After the initial polymerization, we can see the zigzag pattern as shown in the figure from top to bottom, in which the middle part is folded inward.

7. Then, as shown in the origami diagram, a pre-fold is left between two points in the middle part of the origami model. The other three corresponding to the same part are also folded in the same way, which also leaves a pre-crease to facilitate the subsequent folding process.

8. After the final completion, we partially extend the origami model.

9. Turn the origami model over at this time.

10, rotary origami model.

1 1. Fold the bottom up and start remodeling the origami roses. The key point of remodeling is actually to do some summer folding finishing at the flower identification of origami roses.

12, you can see that the finally finished handmade origami rose is also very beautiful!