As shown in the figure, add brown and knead it into light brown.
Take the proportion of white, flesh color and light brown as shown in the figure.
White friction strip
As shown in the figure, the lower part is short and the upper part is long.
The pill stick poked out the groove.
Flesh-colored friction strip
As shown in the figure, one end of the flesh-colored strip is put into the groove.
Brown friction strip
flatten out
Glue it as a sole.
Complete effect
Dry your face (home tutorial) and feet in advance for later use.
After rounding a mass of light brown, use a pill stick to make a face-sized groove.
Put your face in the groove. Press the edge evenly and firmly with your hands.
The utility knife pressed out the lines on the brim.
Press two equal balls out of the groove with a pill stick.
Insist on wearing a hat
Side view
Brown friction strip
After the whole body is slightly flat, press half of it with your hands to be super flat (the whole body is half bulging and half flat).
Take out the oval shape dried in advance (for body support to prevent the body from collapsing)
A long strip surrounds the dry ellipse (the bottom effect is shown below).
(Front view)
Knead two equal parts into slender water.
A small circle with equal drops of water at the bottom.
Squeeze evenly with nine sticks.
Stand your ground.
White strip flattening
Cut out the blade as shown in the figure.
Lace scissors cut out lace (molding is also acceptable)
As shown in the figure, put it on your body as a collar.
White is round and slightly flattened, and is used to make buttons.
The white friction strip is slightly squashed.
Pinch a white cylinder as wide as a white strip.
As shown in the figure, the white bar is folded around the white cylinder.
The toothpick is folded in half and inserted into the bottom of the head.
Assemble the head, body and skirt as shown.
Two equal portions of meat are round in color. The pill was pressed into the groove. Pointed scissors are used to cut thumbs.
Insist on cuffs
Cut a leg according to the required length.
The toothpick is folded in half and inserted into the leg respectively.
Then insert it into the bottom of the skirt.
A white rubber strip and two balls.
Cut the thin strip in half and stick it on the bottom of the bottle cap.
The small white ball sticks to the bottom of the thin strip. It's done.
polished surface
Back of finished product
In the process of making, if the clay surface is dry and can't stick, it can be bonded with white glue.