Automobile safety film can not only protect our privacy, but also play the role of heat insulation and explosion protection. However, taking pictures of cars seems simple, but it is actually very complicated. It is not done by sticking a safety film, as others say, but by cutting, baking and sticking a film. Today, Bian Xiao will tell you the construction process of a good automobile safety film.

Car inspection: No matter which 4S shop or car beauty center, you should check the condition of the car and make a good record before putting a car film on the customer's car.

Vehicle protection: Before cleaning and pasting the vehicle, it is necessary to cover the inside and outside of the vehicle with a protective cover, such as the front hood, trunk, dashboard and seat. In addition to the protective cover, protective pads and doorsill pads should be placed to avoid soiling or scratching the body and interior decoration during construction.

Film cutting: The cutting of front and rear glass films and side glass films of automobiles must be carried out according to the size and radian of the glass. It is very necessary to find a master with high technical level.

Glass surface cleaning:? After spraying water on the glass surface, sludge is removed to remove the stained particles on the glass surface, and then the glass is scraped with water. Next, spread talcum powder evenly on the glass surface to dry the whole glass surface.

Baking film: align the cut film, spread it on the corresponding glass, and then adjust the temperature of baking gun to 350 degrees. When baking, pay attention to the heating degree of the film and the moving speed of the baking gun until the whole film is basically flat with the film. Wait for the film to be flat for a few minutes. After the glass is cooled, spray the installation liquid, then scrape the film flat, clean it with water, and then roll the film.

Dust removal: after baking the film, start the construction dust removal equipment to remove dust from the whole construction workshop, so as to reduce the dust in the work and improve the construction quality.

Cleaning the inner surface of glass: It is also important to clean the inner surface of glass, because the solar film is attached to the inner side of glass, so it is also important to clean the inner side. Usually it will be washed three times to remove pimples and stains.

Mounting: After cleaning, you can basically start mounting. You need to spray a little installation liquid on the glass, then paste the car film, adjust the position left and right up and down, and then use a scraper and baking gun to match the film. When trimming, you can also wrap the cloth with a scraper and trim the edge with a baking gun at low temperature, which can further exert the viscosity of the adhesive and prevent the bubbles on the film edge from reworking.

Self-inspection: After the vehicle is painted, the mechanic needs to do a self-inspection to see whether there are bubbles on a glass, whether all the articles in it are in place, and whether the vehicle has a reminder. And then you can return the car to the customer.

Opus reminded that in order to make the car safety film play the best energy efficiency, every link can not be less. This is the truth of "three-part film, seven-part paste".