2. Auto Fine-tuning: when selected, it will be automatically extruded after automatic layout (this option is invalid when the forbidden area is set).
3、
Select "Mixed Arrangement": All slices are mixed and arranged.
Select "Single Piece Grouping": each piece is a group, arranged according to segment difference (color difference).
At this time, "Overlap between groups" will be activated. When it is set to "-1", the two groups will automatically overlap by a small amount.
& gt all groups can overlap at 100 cm.
When set to "0", the tails of each group are aligned and do not overlap.
0~ 100 cm overlap according to the set amount.
Select "Mixed Grouping": the following dialog box pops up.
There is one group automatically. The list box on the left shows the parts of the current group, and the list box on the right shows the parts that are not grouped.
Double-click the part name in the list box on the right to add it to the current group.
Double-click the name of the chess piece in the left list box to delete it from the current group.
Add Group: Add a group.
Delete Group: Delete the current group.
Edge chromatic aberration: vertical grouping of parts in a single group.
"Only one group": all parts are in one group (mainly used to set the color difference of the edges when parts are few)
"Two-piece Group": Set all the chess pieces into a two-piece group (in order). There is color difference on the lower edge.
"Three-piece group": all three pieces are set as a group (in order). The color difference below is boundless.
"Overlap between groups" is described above.
Used to set the grouping of corresponding beds during continuous discharging.
When all fabrics are arranged continuously, groups of corresponding beds of corresponding fabrics are set.
Clear: Clear all groups and return.
OK: Accept the current settings.