The edge of the knitting needle pattern is a fishbone needle with a length of about 19cm, which can prepare the inside of the needle. Similarly, weave with zero thread, leave a little pink hem for sewing, and hook the two layers together with a row of short needles.
If you want to knit a bonnet, you should first prepare needles and threads, and then make the edge of the pattern into fishbone-like needles when knitting.
Then when the knitting length is about 19cm, we can prepare to close the needle, and we can also use the same method when knitting the lining. It is woven with zero thread, and then we can leave a little pink hem, and then we can sew them up.
When we want to sew, we need to hook a row of short stitches on two layers, and then we can sew them together. Prepare knitting needles and thread first. When knitting, make the edge of the pattern into fishbone-shaped needles.
When the knitting length is about 19cm, prepare to close the needle. When weaving the interior, use a zero line. Leave a little pink hem. When sewing, the two layers are hooked with a row of short needles and just sewn together.
First, get ready to stick needles and needles, and start sewing 40 stitches as a demonstration. Specifically, in the process of knitting hats, you should measure your head circumference first, and then start knitting.
Then after picking up the needle, use the edge of the lower knitting hat to knit three stitches on average. Then continue to knit the next stitch after the head and tail are connected. Then, after knitting to a length of 1 inch, the knitting method will be changed to lower knitting and upper knitting. Start knitting the hat body.
Then, after the cap body is woven into the required length, the needle changing method is started. Knit a circle and sew a needle. Then start to reduce the needle. The way to reduce the needle is to knit a lower needle first, and then combine the two needles. Repeat the operation to finish knitting this loop. Then the second lap began to reduce the needle, just like the first lap. One stitch, two stitches and one knit.
After that, there were 12 stitches on the bar needle, so the thread was broken and the thread was threaded into a coil. Then tighten it on the reverse side. Be careful to leave an extra 20 cm for disconnection. This is convenient for threading. Then, turn it over and tidy it up, and the hat is finished. Finally, decorate a little flower to increase the aesthetic feeling.